Vintage Audio M76 Specifications download pdf (Page 5)

Front Panel Controls Overview

Input Control: Here the user is able to adjust the amount of input level sent into

the M76’s internal circuitry. The input level attenuator determines how much of

the signal is over the threshold and therefore compressed.

Output Control: The output control allows the user adjust the amount of level that

is being sent to the output section and output transformer. This is post compression

and only affects the output level of the M76. The user can also choose to drive the

transformer and output section.

Zero Adjust: Between the Input and Output control is a small hole. Using a small

flat blade screw driver the user can adjust the Gain Reduction Zero point. The M76

is a sensitive device and generally will require that the meter be zeroed once the

device is settled in the rack after unpacking. While VU meters are not completely

accurate they do provide a good general reference and occasional will need to be

calibrated.

Attack Control: The attack control is completely variable and allows for attack

times of: 20uSec - 800uSec.

Release Control: The release control is completely variable and offers release

times of 50 mili Sec - 1.1 Sec’s.

Link Switch: (See Linking)

Note one unit must be set internally to Slave and the other to Master for the link to

be active. If you bought a Stereo Pair they should already be set accordingly.

1 2 3 4 5 6 7 8 9

No comments

Vintage Audio M76 Specifications Page 5